UM - CODE N1 N2 N3 N9 - REV 0.3
3. Open the box and take out the copy of
the instruction manual which is on top of
the polyurethane protection;
4. Continue as indicated in the manual;
5. Push the upper cardboard box down (1)
using the flaps so that the next step is
easier, that is, removing the
polyurethane protection and the corner
reinforcements (2);
6. Remove the above mentioned
protection and the corner
reinforcements;
WARNING: Blade may be exposed!
7. Lift and take out the machine which is
wrapped in a sheet of transparent
polyethylene;
ATTENTION: The machine must be lifted
by two people, taking into account that it
weighs more on the side where the blade
is.
8. Once this operation is over, check the
contents of the box and make sure it
corresponds to the label on the outside.
1
2
14
To Next Page
Loading...
