Berkeley S.A.E. User Manual

F00636 Page 23
General Information
Pump Nomenclature
MODEL
S.N. OR DATE
IMPELLER DIA.
BERKELEY PUMPS
B.M.
344 1093
Record your nameplate data here.
ORDERING REPLACEMENT PARTS:
Locate the Berkeley nameplate on the pump, plate is normally
on the bearing bracket. Information found on this plate is
shown below. To be sure of receiving correct parts, provide all
nameplate data when ordering. The BM (Bill of Material)
number is most important. Write your nameplate information
on the blank nameplate below for future reference as
nameplates can become worn or lost.
The illustrations on Pages 24 and 25 shows typical components
used in the assembly of S.A.E. mount centrifugal pumps. Refer
to these drawings when ordering any replacement parts.
MODEL
S.N. OR DATE
IMPELLER DIA.
BERKELEY PUMPS
B.M.
788 0394
B54598
G100894
B3TPMS
6-1/8"
SAMPLE ONLY
B3ZQM
9.00”
G123094
B65999
Job name Order Number
Model
Engine Manufacturer
Flywheel Housing Dimensions (From page 5)
Flywheel Dimensions (From page 7)
From Table I, Page 5 , SAE Housing Size is:
Measured Dimensions For:
For Pump Model AtHP Req'd RPM
"A"=
"E"=
"H"=
In.
In.
"F"=
In.
"G"=
"F1"= "F2"=
In.
In.
In. In.
In.
"B"=
Dim. "BC"=
Hole "C"=In.
In.
Hole "C"
Qty: Size:
Qty: Size:
If all even except one, center to center of odd hole is
For Fig. 4 symetrically grouped set of holes:
"Standard" Flywheel Coupling from Table IIA, IIB, IIC or Table III: (From page 7)
1463 0195
Engine Flywheel Dimension Form

Berkeley S.A.E. Specifications

General

Brand	Berkeley
Model	S.A.E.
Category	Water Pump
Language	English