Need help?Do you have a question about the Bernard Controls EZ Series and is the answer not in the manual?
General| Brand | Bernard Controls |
|---|---|
| Model | EZ Series |
| Category | Controller |
| Language | English |
How to manually operate EZ4-EZ15 actuators by engaging and disengaging the handwheel.
Operating EZ100-EZ1000 actuators with automatic declutching handwheel for manual control.
Using the clutch lever on EZ60 actuators to disengage the motor for manual operation.
Essential checks for power supply, cable glands, and functional testing of limit/torque switches.
Adjusting physical stops and calibrating travel limit switches for precise actuator movement.
Steps to mount and adjust the potentiometer on the switch plate for circuit board installations.
Guide to mounting and adjusting potentiometers on EZ4-EZ15 actuators with support columns.
Introduction to MINIGAM+ controls for valve positioning and signal types.
Key considerations for wiring MINIGAM+ for analogue signals and remote position feedback.
Steps to set the 0% signal for the remote position feedback.
Steps to set the 100% signal for the remote position feedback.
To Next Page