6 7
MACHINE OVERVIEW AND INSTALLATIONMACHINE OVERVIEW AND INSTALLATION
SETTING UP YOUR MACHINE
1. Wipe off excess oil in the needle plate and bed areas.
2. Foot Control
Push foot control plug into connector socket, and connect the power line
plug into power supply outlet.
3. Power / Light Switch
Your machine will not operate unless the power/ light switch is turned on.
This same switch controls both machine power and sewing light.
When leaving the machine unattended, or servicing the machine, remove
the power line plug from supply outlet.
4. Opening Front Cover
To open front cover, pull it to the right and down towards you.
5. Opening Working Table
To open working table, pull the release lever towards you with your right
hand, and lift the front of presser foot up with your left hand.
PREPARATION FOR THREADING
Thread Guide Pole
pole to the highest point until you hear it click. Place thread spools on pins and
draw thread through thread guides on the pole from rear to front.
Thread guide of pole can hold thread spools on the spool stand by pulling
down the pole as illustrated.
SPOOL CAPS FOR DOMESTIC TYPE SPOOLS
SPOOL DISC AND SPOOL HOLDERS FOR CONE SPOOLS
For large cone spools use the spool holders with the wide end at the top, and
for small ones, use the same spool holders but with the narrow end at the top.
SPOOL NETS
Polyester or bulky nylon threads become loose while unwinding. To keep
consistent feeding of such threads, utilize spool net sleeving over the spool.
MACHINE SETUP
Illustration
I. Connector socket
II. Power/light switch
III. Release lever
IV. Working table
V. Front cover
Illustration
I. Thread guide
II. Thread guide pole
Illustration
I. Spool cap
II. Domestic cotton reel
III. Cone type thread
IV. Spool holder
V. Spool disc
VI. Thread comes off the top
VII. Net
VIII. Turn up
IX. Spool
To Next Page
Loading...
