Bernette b35 - bernette Presser Feet

7
bernette SEWING MACHINE WORKBOOK
BERNETTE PRESSER FEET
Every machine needs a presser foot to hold the fabric in place against the feed dog, helping to
move it under the needle for stitching. Along with an all-purpose foot for general sewing, other
presser feet for specic tasks are included with bernette machines.
The presser feet are easy to attach with snap-on soles that take only a few seconds to change when
needed. In addition to the standard presser feet included with each model, there are additional optional
presser feet available for special techniques. For more information go to http://mybernette.com.
sew&go b33 b35 b05
Zigzag Foot – An all-purpose presser foot, the Zigzag Foot
works well for most general sewing situations - seaming,
topstitching, basting, gathering, etc., using the practical/
utility stitches of the machines. Also useful for sewing open
decorative stitches but heavy satin stitches may cause the foot
to drag on the dense thread build-up.
   
Zipper Foot – This narrow foot lets the needle stitch next to
the zipper coil. Place the edge of the foot next to the zipper
coils and the needle stitches parallel to them.
  

Satin Stitch Foot – Intended for sewing over heavy
decorative stitches such as satin stitches, the sole of
this foot is designed to move easily over dense thread
build-up.
 
Open-toe Embroidery Foot – The cut-out behind the needle
allows for smooth decorative stitching, and the clear sole and
open toe provides a clear view of the stitching area.
* *

Darning/Embroidery Foot – This spring-loaded foot is
designed specically for quilting and sits just above the fabric
when the presser foot is lowered, making it possible to move
the fabric by hand to follow a design or motif.
* *

Blindstitch Foot – Used with the blindstitch, this foot creates
a hem that is inconspicuous from the right side of the fabric.
  
*Optional accessory available from your local dealer.