Bernina Bernette b37 - Buttonhole with Cord

36
Buttonhole with cord
Stitch pattern: 00
Thread tension: 1 - 5
Presser foot: Buttonhole foot with slide
Use the same procedure as the standard buttonhole proce-
dure. Set the stitch width to match the thickness of the cord
used.
With the buttonhole foot raised, hook the filler cord on the
spur at the back of the buttonhole foot. Bring the ends
toward you under the buttonhole foot, clearing the front end.
Hook the filler cord into the forks on the front of the but-
tonhole foot with slide to hold them tight.
Lower the needle into the garment where the buttonhole will
start, and lower the foot.
Spur
Forks.
Start the machine and sew the buttonhole. Both sides of the
buttonhole and the bartacks are sewn over the filler cord.
Remove the fabric from the machine, and cut the sewing
threads only.
Needle thread (top thread)
Bobbin thread (bottom thread)
PLEASE NOTE:
Cut the filler cord at both ends, if the filler cord is stitched
on the fabric and cannot be pulled.
0
R
17
F
34
F
1
A
18
R
35
F
2
A
19
R
36
A
3
A
20
R
37
A
4
A
21
R
38
F
5
A
22
F
39
F
6
A
23
F
40
F
7
A
24
F
41
F
8
A
25
F
42
F
9
A
26
F
43
F
10
A
27
F
44
F
11
A
28
F
45
F
12
A
29
F
46
F
13
F
30
F
47
F
14
A
31
F
48
F
15
F
32
A
49
F
16
F
33
F
Pull the loose ends of the filler cord to tighten it. Thread the
end of the cord through a hand-sewing needle. Then draw
them to the wrong side of the fabric and knot.