18
Draw the end of the thread around the upper thread guide.
Threading the Machine
• Threading the Machine
CAUTION:
Turn OFF the power switch before threading the machine.
While holding the thread near the spool , draw the end of
the thread down around the check spring holder .
Spool
Check spring holder
Firmly draw the thread up from right to left over the take-up
lever, and down into the take-up lever eye.
Pass the thread through the lower thread guide. Slide the
thread behind the needle bar thread guide on the left.
Thread the needle from front to back, or use the needle
threader.
Raise the presser foot. Press the needle stop
up/down button to raise the thread take-up
lever to its highest position.
Needle stop up/down button
To Next Page
Loading...
