Setting up the machine
45
> Guide the needle inserter from below over the needle and loosen the needle screw using the supplied
screwdriver Hex.
> Remove the needle downwards and place it in the needle box or the needle pad behind the threader
cover.
> Insert the new needle with the flat side to the back into the needle inserter.
> Push the needle into the corresponding Needle Holder opening as far as it will go.
> Check the needle position in the needle checking window.
> Tighten the needle screws.
Needle pad
The needle pad is located behind the threader cover and is used to store needles that are not being used.
To Next Page
Loading...
