Bernini Be242 - Activating the Password; Changing the Password; Removing the Password; Loosing the Password

Be242 Be242RB Be242-22 OEM's Manual V4.X.XX - March - 2023 page 11
11
6.40 Activating the password
1) - Enter the programming mode as indicated in section 6.10.
2) - When the display shows [P.0], push the [ACK-F10] push button for about 10 seconds until the display shows
[PPPP]. When the display will indicate [4242], release the button. The two digits on the right will blink.
3) - Push [TEST] or [AUTO] in order to choose a code.
4) - Push [←F8] to select the 2 digits on the left side. Repeat step 3) in order to choose a code
5) - Press the [OFF] push button if you want to exit the procedure without activating the password.
6) - Press and hold the [ACK-F10] and [F9→] push buttons simultaneously until the [SAVE] message appears;
the Be242 saves the password and remains in PROGRAM mode. To exit, push the OFF push button. You can
change the password at any time as indicated in section 6.50.
6.50 Changing the password
1) - Enter the programming as indicated in section 6.10 and table 6.11. When the display indicates the
parameter [P.0], push and hold the [ACK-F10] push button for about 10 seconds until the messages [PP.PP] and
[4242] appear. The two digits on the right side of the display will blink.
2) - Push [TEST] or [AUTO] in order to choose a code.
3) - Push [←F8] to select the 2 digits on the left side. Repeat step 3) in order to choose a code
4) - Press the [OFF] push button if you want to exit the procedure without activating the password.
5) - Press and hold the [ACK-F10] and [F9→] push buttons simultaneously until the [SAVE] message appears
(approximately 5 seconds); the Be242 saves the password and remains in PROGRAM mode. To exit, push the
OFF push button.
6.60 Removing the password
1) - Enter the programming mode as indicated in section 6.10 part 3 (you are required to use the old password).
2) - When the display indicates the parameter [P.0], push and hold the [ACK-F10] push button, for about 10
seconds until the display indicates in sequence [PPPP] and [4242]. The two digits on the right side will start to
blink. The code [4242] disables the use of the password. Follow step 3 of 4 according to your needs.
3) - Press the [OFF] push button if you no longer want to remove the password (exits the procedure).
4) - Press and hold the [ACK-F10] and [F9→] push buttons simultaneously until the [SAVE] message appears
(approximately 5 seconds); the Be242 saves the code [4242] that disables the password. The Be242 remains in
PROGRAM mode. To exit, push the OFF push button.
6.70 Losing the password
In case you lose the password follow the steps:
- remove the supply
- push and hold the [ACK] and [>] push buttons
- apply the supply; a 4-digit code appears on the display
- send the code to bernini@bernini-design.com together with your credentials.
- you will receive the new password in 24 hours.
Section 7.0 Programmable Parameters
The programmable parameters are divided into classes as indicated below.
7.01 - A, B - Mains Failure Control 7.07 - Input Options List
7.02 - A, B - Generator Parameters 7.08 - Programmable Outputs
7.03 - A, B - Engine Parameters 7.09 - Output Options table
7.04 - Alarms Options
7.05 - Miscellaneous
7.06 - Programmable Inputs