6
Step 6: Just like the large bowl and
base, the fountain bowl uses a key
system that will lock it to the middle of
the large bowl.
Be sure to leave enough length of
cord coming from the water pump
so the pump will sit on the bottom
of the large bowl when the fountain
bowl is assembled.
Step 7: Connect the fountain bowl to
the large bowl and turn the fountain
bowl about a quarter turn clockwise to
lock it into place.
STOP!
At this point, your fountain should look like the image on
the left. Go to the next page for the next step to setup
your new Bernini Fountain.
To Next Page
Loading...
