5
Step 1: Inside the fountain
bowl you will nd a green
banded cord attached to the
water pump. Feed this cord
into the pipe in the middle of
the large bowl.
The fountain bowl will install
into the middle of the large
bowl assembled in step 1.
Step 2: Rest the fountain
bowl on the side of the large
bowl and feed the LED light
power cable down into the
pipe.
NOTE: If the cables slip
out of the rubber stopper
you can press the cable(s)
into the slit(s) in the side of
the rubber stopper until the
cord(s) t snugly into the hole
inside in the middle of the
rubber stopper.
Step 3: Press the plug into
the pipe in the middle of the
large bowl.
If you are having trouble
pressing the plug into the
pipe, you can rub a little
bit of soapy water on the
plug to help it slide into
place.
Step 4: To ensure that you
have a good seal, make
sure the plug ts snugly as
pictured above.
If your fountain came with the water pump disconnected from the tube inside of
the fountain bowl, refer to page 26 for instructions on how to connect the water
pump to the fountain bowl.
To Next Page
Loading...
