82527 Vantage 25
3.4 PARKING BRAKE
The parking brake is placed on the left side of the
sprayer.
To immobilise or release the sprayer's brakes.
Take the handle (1) and t it into the control nut (2).
In direction (4), the brakes are applied.
In direction (5), the brakes are released.
Replace the handle (1) on its support, after use.
Brake in case of a break in the tow coupling:
To ensure that the machine is guided in case the tow
coupling breaks, attach the parking brake cable (3)
to a xed and robust point on the tractor.
36
1
2
3
3
4
37
3.5 ADJUSTMENT OF THE DRAWBAR
Various types of drawbars and booms can be tted
on the machine.
The rear axle (4), according to these types,
occupies:
Position P3 or P4 (short drawbar).
Position P1 or P2 (Flexia drawbar).
The front axle (1) remains xed.
To change the position of the rear axle (4):
Immobilise the machine.
Remove the screws (3) from both sides and the stop
plates (2) with their guide bearing.
Tap out the rear axle (4), if necessary making use of
the holes (T) on the chassis.
38
32
T
P1
P2
4 P4 P3
1
Put into the desired position and ret the rear axle
(4), the guide bearings, the stop plates (2) and tighten
the screws (3).
3.6 RINSING BEFORE FIRST USE
WARNING:
Before rst use of your sprayer with the phytosanitary product
(herbicide, insecticide, or other), completely rinse the machine.
Unscrew the nozzles if they are tted.
Unscrew the end plugs on the pipes.
Fill 1/5 of the volume of the tank with water.
Spray (
4.4).
Disassemble and clean the lters.
NOTE:
Any foreign particles which may be in the
sprayer circuit will therefore be eliminated
and will not risk plugging the nozzle outlets.
Re-tighten the end plugs on the pipes.
Fit the nozzles.
5
To Next Page
Loading...
