82527 Vantage26
3.7 USAGE ADVICE
At Start-up:
Switch on the tractor's engine.
Switch on the control unit using the switch (1).
Engage the power take-off.
Check:
- At the start of the spraying season, always check the
nozzle ow rate at a pressure of 3 bar for 1 minute.
Reset the new value. If this value is greater than the
IMPORTANT:
During the factory tests, the electronic
control unit was programmed with
theoretical values corresponding to the
characteristics of your sprayer. You must
in all cases check and if necessary correct
the set values.
WARNING:
All valve operations must be performed
with the PTO off.
When folding the arms of the boom.
Leave a gap (2) of at least 150 mm,
between the top of the tank and the main
arm of the boom.
R
5780 L
50%
39
1
40
2
initial value by 10%, it is necessary to replace the
nozzles.
To Next Page
Loading...
