Beta RR 125 cc - Page 33

33
1
GENERAL INFORMATION
CONOSCENZA DEL VEICOLO
Capacità di riempimento (ENDURO / MOTARD / RE)
• serbatoio carburante .........................................5,7 (lt)
di cui lt di riserva ....................................................1 (lt)
• olio motore ...........................................................1,2 (lt)
Sospensione anteriore ENDURO - MOTARD
• forcella idraulica con steli di Ø 40 mm
Olio contenuto nei gambi:
- destro (livello con tubo a fi ne corsa 185 mm) ....235 cc
- sinistro (livello con tubo a fi ne corsa 185 mm) ...235 cc
Sospensione anteriore RE
• forcella idraulica con steli di Ø 37 mm
Quantità olio per stelo ......................................320 cc
-
livello con tubo a fi ne corsa e senza molla ....160 mm
Sospensione posteriore (ENDURO / MOTARD / RE)
• monoammortizzatore con regolazione precarico molla
• Corsa ammortizzatore .......................................52 mm
Freno anteriore ENDURO - MOTARD - RE
• a disco Ø 260 mm con comando idraulico.
Freno posteriore ENDURO - MOTARD - RE
• a disco Ø 220 mm con comando idraulico
Filling capacity (ENDURO / MOTARD / RE)
• fuel tank ................................................................5.7 (lt)
including reserve of ...............................................1 (lt)
• engine oil ..............................................................1.2 (lt)
Front suspension ENDURO - MOTARD
• hydraulic fork with 40 mm Ø rods
Oil content in shafts:
- right
(oil level with tube at the end of its stroke 185 mm) ...235 cc
- left
(oil level with tube at the end of its stroke 185 mm) ...235 cc
Front suspension RE
• hydraulic fork with 37 mm Ø rods
Quantity of oil for rod .........................................320 cc
- oil level with tube at the end of its stroke without spring .. 160 mm
Rear suspension (ENDURO / MOTARD / RE)
• single shock absorber with spring preload adjustment
• shock absorber travel ........................................52 mm
Front brake ENDURO - MOTARD - RE
• disk-type with hydraulic control Ø 260 mm
Rear brake ENDURO - MOTARD - RE
• disk-type with hydraulic control Ø 220 mm