EasyManua.ls Logo

Beta RR 125 cc - Starting the Engine and Using Side Stand

Beta RR 125 cc
248 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OPERATION AND USE
47
2
FUNZIONAMENTO E UTILIZZO
A
RES
ON
OFF
STARTING THE ENGINE
Insert the key in the ignition switch,
turn it clockwise and ensure that
the neutral indicator (N) on the
instrument panel is lit.
Warning: To minimize battery con-
sumption, before turning the key
ensure that the dip switch is in the
low beam position (see page 8).
Turn fuel cock A:
OFF = closed
ON = open
RES = reserve
Electric starting
Pull the clutch lever while push-
ing the start button on the throttle
control without turning the throttle
twist grip.
Kick starting
Kick down the lever down and
then bring it back to its home
position.
Note: Turn on the starter when the
engine is cold by pressing the lever
B, start the vehicle, wait a few min-
utes, then bring the lever back to its
starting position.
Note: In the case of gas tube
disassembly, close needle tap C,
accessible from the left side of the
motorbike. Once the tubes are
reconnected, remember to open
the fuel cock.
B
AVVIAMENTO DEL MOTORE
Ruotare la chiave nel commuta-
tore in senso orario ed assicurarsi
che la spia del folle (N), posta sul
cruscotto, sia accesa.
Attenzione: Ricordarsi, prima di
girare la chiave, di posizionare il
pulsante deviatore luci in posizione
anabbagliante (vedi pag. 8), in
maniera da ridurre il più possibile
il consumo della batteria.
Ruotare il rubinetto benzina A:
OFF = chiuso
ON = aperto
RES = riserva
Avviamento elettrico
Tirare la leva frizione e contempo-
raneamente spingere il pulsante
avviamento sul comando gas
senza ruotare la manopola gas.
Avviamento con leva messa in moto
Intervenire sulla leva messa in
moto, affondando con il piede
un colpo deciso, quindi riportare
la leva in posizione di partenza.
Nota: A motore freddo inserire lo
starter, azionando la leva B, avviare
il veicolo, attendere alcuni istanti,
quindi riportare la leva nella posi-
zione iniziale.
Nota: In caso di smontaggio tubi
benzina chiudere il rubinetto a
spillo C accessibile dal lato sinistro
della moto. Una volta ricollegati i
tubi ricordarsi di aprire il rubinetto.
C

Table of Contents

Related product manuals