EasyManuals Logo

Beta RR 50 cc ENDURO Manual

Beta RR 50 cc ENDURO
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
1
GENERAL INFORMATION
13
GB
Using only the internal battery:
• With the LO symbol, the backlighting will not switch on. The symbol appears
when the battery voltage is lower than 2.45V.
Reset Button:
Using the Reset button, located on the back of the instrument, all travel data will be
deleted, including date and time.
Internal battery:
The instrument houses a 3.0V internal button cell battery (CR2032). The instrument can
only work with this battery. The symbol appears when the battery is running
low. To change the battery, unscrew the cap located on the back of the instrument
using a coin.
Once the battery has been changed, make sure that the positive side is facing
outwards.
REPLACE THE BATTERY WITH ANOTHER CR2032-TYPE BATTERY.
2 SETTING THE PARAMETERS
General information:
Allowed settings:
• Km/h (kilometres per hour) or M/h (Miles per hour)
• Wheel size (rolling circumference) [mm]
• Clock format: 12-hour / 24-hour
• Current date
• Maintenance
TO ENTER THE PARAMETER SETTINGS MODE HOLD DOWN THE RIGHT AND LEFT
BUTTONS FOR APPROX. 3s.
THE WORD “Unit” WILL FLASH ON THE DISPLAY.
The operational logic is structured as follows:
• The instrument enters SETUP mode displaying the parameters according to the
sequence listed above.
• The instrument displays the parameter to be changed for a few seconds in fl ash
mode.
• If you wish to change the parameter displayed for those few seconds simply
edit the values by pressing the right and/or left buttons (according to the modes
listed below), otherwise wait a few seconds (approx. 5 s) to proceed to the next
parameter.
• When the parameter has been edited to the desired value, the instrument au-
tomatically moves onto the next setting, there is no need to press any button of
confi rmation.
• If you only wish to enter the setup mode to view the confi gured settings, simply wait
without pressing any buttons; the instrument will display all of the set parameters
and will then automatically go back to “Normal Mode”.

Other manuals for Beta RR 50 cc ENDURO

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Beta RR 50 cc ENDURO and is the answer not in the manual?

Beta RR 50 cc ENDURO Specifications

General IconGeneral
BrandBeta
ModelRR 50 cc ENDURO
CategoryMotorcycle
LanguageEnglish

Related product manuals