Beta RR 50 cc ENDURO Manual

3
CHECKS AND MAINTENANCE
36
GB
FRONT BRAKE
Check
To check the wear of the front brake pads,
visually inspect the caliper from below. The
lining on the visible ends of the two brake
pads should be at least 2 mm thick.
If this layer is thinner than 2 mm, replace
the pads immediately.
Note:
Check the brakes every 2.500 km/1.500
miles.
To replace, contact authorised Betamotor
customer service.
REAR BRAKE
Check
To check the wear of the rear brake pads,
visually inspect the caliper from below. The
lining on the visible ends of the two brake
pads should be at least 2 mm thick. Should
the lining be thinner, immediately replace
the brake pads.
Note:
Check the brakes every 2.500 km/1.500
miles.
To replace, contact authorised Betamotor
customer service.
2 mm
2 mm

Beta RR 50 cc ENDURO Specifications

General

Engine Type	Single cylinder, 2-stroke
Displacement	49.7 cc
Transmission	6-speed
Fuel System	Carburetor
Seat Height	920 mm
Weight	85 kg (dry)
Fuel Tank Capacity	6.5 liters
Cooling system	Liquid cooled
Rear Suspension	Monoshock
Starter	Kick
Front Suspension	Hydraulic fork
Front Brake	Disc, 260 mm
Rear Brake	Disc