Better Packages Inc. 19
Length Sensor
(Note: Always unplug machine when performing service to machine)
Procedure
1. Remove left side cover. Remove the keypad membrane from the
control board and lay the cover on the bench
2. Remove the 2 screws holding the sensor in place and remove
connector from board
3. Place new sensor on machine and fasten with the screws and replace
the connector to the board
4. Replace the keypad membrane back onto the board
5. Replace the cover back onto machine
2 SCREWS
Water Level Adjustment
To adjust the water in the tank to the desired level slide the water level adjuster
to the left to decrease the water level and slide adjuster to the right to increase
the water level in the water tank.
adjuster
To Next Page
Loading...
