Bewator Telecode 5000 - Open the Door on Hang-Up On;Off

31
Doc. No. 002 Issue 2 April 1998
Open the door on hang-up on/off
Normally, the unit is set so that the entrance door is only
opened when the tenant dials 5 on his telephone dialpad. The
effect of this setting is that the door is also opened on hang-up
or time-out.
N.B. THIS FUNCTION MUST NOT BE USED WITH
ANSWER CHOICE 2.
Proceed as follows:
1 Go to the Options menu and browse to the Open on hang-up
function (follow the initial instructions in the Change call
duration time section on page 27). The following text is displayed:
/ TO SCROLL
OPEN ON HANG-UP
2 Press . The following text is displayed:
ENTER 1 (ON) / 0 (OFF)
(1)
3 Press 1 (means that the door is opened when the tenant
replaces the handset).
4 Press . The following text is displayed again:
/ TO SCROLL
OPEN ON HANG-UP
5 Press
Esc
to go back to the stand-by position or browse to
another function and continue programming.
4. PROGRAMMING