Safety
2-1
2 Safety
2.1 Intended use
The flame scanner shall be used exclusively to detect
flames in combination with a suitable flame amplifier. The
flame scanner and flame amplifier together constitute a
complete flame amplifiering system for burners with a
random capacity and random fuels in single and multiple
burner systems.
The flame amplifier renders available to the burner control
the safety-oriented binary signals for "Flame ON/OFF".
On account of the continuous fully electronic self-test of
its function, the flame scanner is approved for continuous
operation.
Danger when improperly used !
The device may cause hazards if it is not used as in-
tended and/or for any other purposes.
The device has to be used only for the purposes for which
it is intended.
The procedures described in the operating instructions
have to be observed.
The manufacturer/supplier shall not be liable for damage
resulting from use for non-intended purposes. The
user/operating company alone shall bear the risk.
To Next Page
Loading...
Need help?
General
