BIGREP ONE - Page 69

BigRep ONE 5 BigRep User Interface
69
c. Out of Filament Response: Disable/Enable the Out of Filament
response for the extruders. Set the length of time extruders should
wait for cool down aer running out of filament
d. Pause Wait: Set a default pause wait position on the XY plane
e. Temperature Control Calibration
f. Semi Automatic Bed Levelling
Note: Every time a new user accesses the UI, the code M503 should be typed in
on the terminal to activate the Advanced Menu
Terminal Menu (Fig. 5-6)
Direct G-code programming can be aected via the G-code input field. The termi-
nal also saves the last commands of the printer.
Fig. 5-6: Terminal Menu