BIGREP ONE - Replacing the Protective Print Bed Tape; Maintenance Plan

BigRep ONE 8 Maintenance
89
8.4. Replacing the Protective Print Bed Tape
Damages to the protective foil on the print bed can aect the printing result in
the bottom layer. You can order new protective foil as well as instructions for the
replacement in the customer portal.
8.5. Maintenance Plan
Regular maintenance following the steps described below and executed by
trained personnel constitutes a prerequisite for any claims regarding a warranty
possibly agreed to or regarding services covered by the protection plans.
Regular Maintenance
Daily / Before Every Use
Clean print bed, use isopropanol if needed. & Chap. 8.1. Cleaning
Monthly
Check emergency stop button and safety edge.
Every six months
Lubricate Z-lead spindles (for suitable lubricants see & Chap. 8.1. Lubricate Z-belts
(use silicon based lubricant).