BIGREP ONE - 2 Safety; Explanation of Safety Symbols; Safety Instructions

2 Safety BigRep ONE
52
2. Safety
2.1. Explanation of Safety Symbols
2.2. Safety Instructions
Intended Use
The BigRep ONE is intended for manufacturing three-dimensional printed materi-
als from authorized filament. The models for the components that are to be man-
ufactured are created on the computer with the aid of a specialist slicing soware.
A three-dimensional object is created from the transmitted data by layering melt-
ed filament (extrudate). (Additive manufacturing — FFF: Fused Filament Fabrica-
tion).
This warning indicates a potentially hazardous situation. Nonobservance
may result in severe injuries or death.
WARNING
This warning indicates a potentially hazardous situation that may result in
moderate or light injuries.
CAUTION
Important information calling for special attention. Damage will occur if pre-
cautions are not taken).
This warning indicates an imminently hazardous situation. Nonobservance
will result in severe injuries or death.
DANGER
The use of unsuitable filament can lead to negative printing results and
impurities or damages to the printer as well as printer failure.
The printer may only be used for additive manufacturing — FFF
This warning indicates hazardous electric voltage.
This warning indicates head-level obstacles.