BIGREP ONE - Page 71

BigRep ONE 5 BigRep User Interface
71
Web Interface Main Page
The main page of the website interface is shown on the image
a. On the State section, you will have live information about the
currently active print job, the remaining print time and the status of
the 3D printer.
b. On the Files section, you can upload your G-Codes and start your
prints.
c. On the Temperatures section, you can monitor the temperatures of
the extruders and bed.
d. If you have a Webcam installed, you can watch the stream here.
Fig. 5-8: Web Interface Main Page