BIGREP ONE - Page 75

BigRep ONE 6 Operation and Control
75
Resume Print
Printer will start a resuming procedure:
› It will set back the temperatures of the bed and extruders
› It will start the Home-To-Max procedure to identify its position:
– The extruders will move up to the highest Z position (Zmax), then
Home X and Y
– The printer will automatically move back down again to 10mm above
the stopped location to heat the nozzle and prepare to print
Aer this procedure
› Go to the Temperature Menu and check that the bed and the extruders
have reached their correct temperatures.
› It is recommended to extrude 100mm to verify material quality and flow
› Click on the Start Print button to resume the print.
Cancel Print
The UI will go to the standard menu, and the print will not be recovered
Removing the Printed Object
› Once the printed object is completed, the extruder moves to its wait posi-
tion and the print can be removed.
› Wait for the print bed to cool down to room temperature before removing
the print.
› Carefully remove the object from the print bed, use the delivered scraper if
necessary.
Turning O the Printer
› Close BigRep Controls
› Click on Home > Logout > Shutdown
› Turn o the machine using the main switch (O)
Removing the printed object before the bed has cooled down
bears the risk of irreversible damage to the object’s shape!