18
CAUTION
1) Confi rm the powder cap is attached fi rmly. An unstable attachment will cause the powder cap to undo during use and may
cause injuries or powder scattering.
2) Make sure the powder stirring cap is attached. Improper attachment will lower the cleaning effi ciency.
3) Remove powder remaining in/on the screw threads of the main body, powder cap, and sealing surface of the powder seal.
If the powder adheres fi rmly and is hard to remove, clean the remaining powder according to the instructions in “8.1 3)
Cleaning and disinfection”. As the remaining powder may cause premature wear of the threads and insuffi cient sealing
which may cause powder scattering.
4) Before each use, check if the screw threads of the main body and powder cap have any damage such as wear, crack,
deformation, etc. If the main body or powder cap has a damage, do not use and ask your dealer for repair together.
5) If the triangle symbol on the powder cap lies outside of the mounting position mark while the polisher is in use, this may
cause trouble like crack, damage or premature wear of the threads of the main body and powder cap.
ATTENTION
1) Remove water, oil, or powder remaining in/on the head, coupling of chamber unit, powder chamber, and powder cap.
Otherwise, the powder will get damp and cause clogging.
2) Do not overfi ll with powder.
3) Do not shake polisher after fi lling the powder. The powder may leak from the nozzle.
4) Always use dry compressed air and dry powder. Use of air and powder containing moisture or oil will cause powder
clogging.
18
CAUTION
1) Confi rm the powder cap is attached fi rmly. An unstable attachment will cause the powder cap to undo during use and may
cause injuries or powder scattering.
2) Make sure the powder stirring cap is attached. Improper attachment will lower the cleaning effi ciency.
3) Remove powder remaining in/on the screw threads of the main body, powder cap, and sealing surface of the powder seal.
If the powder adheres fi rmly and is hard to remove, clean the remaining powder according to the instructions in “8.1 3)
Cleaning and disinfection”. As the remaining powder may cause premature wear of the threads and insuffi cient sealing
which may cause powder scattering.
4) Before each use, check if the screw threads of the main body and powder cap have any damage such as wear, crack,
deformation, etc. If the main body or powder cap has a damage, do not use and ask your dealer for repair together.
5) If the triangle symbol on the powder cap lies outside of the mounting position mark while the polisher is in use, this may
cause trouble like crack, damage or premature wear of the threads of the main body and powder cap.
ATTENTION
1) Remove water, oil, or powder remaining in/on the head, coupling of chamber unit, powder chamber, and powder cap.
Otherwise, the powder will get damp and cause clogging.
2) Do not overfi ll with powder.
3) Do not shake polisher after fi lling the powder. The powder may leak from the nozzle.
4) Always use dry compressed air and dry powder. Use of air and powder containing moisture or oil will cause powder
clogging.
To Next Page
Loading...