Page 35 / 41 IFU_MAL_EN_V6
WARNING
- Disconnect the USB cable before cleaning Mallya.
CAUTION
- Do not wipe the surface of Mallya with chemical products or solvents (e.g. acetone) (other
than those specified in this cleaning procedure) as it could lead to discoloration or
deterioration.
- Please remember that the Mallya is not waterproof:
Do not immerse the device in water and do not clean it under running water.
Do not expose the device to moisture. Do not use the device in the bathroom or in areas
with high temperature, humidity, dust or rain.
- Do not share Mallya with other people to prevent infection.
10.4 MAINTAIN WATER, DUST AND LIGHT RESISTANCE
The device is rated IP22 using the Ingress Protection rating system.
As defined in the IEC standard 60529, the IP code (or Ingress Protection code) classifies and
rates the degree of protection provided by mechanical casing and electrical enclosure against
the intrusion of solid objects, dust, accidental contact, and water.
Mallya is rated IP22 using this Ingress Protection rating system: your device has shown to be
water and dust resistant in certain circumstances Despite this classification, your device is no
manner impermeable to water damage.
NOTE:
If any liquid is found to have entered your device components (inside the sealed system): your
device’s warranty will be void.
Follow the next tips carefully to prevent damage to the device (operational or cosmetic issues):
- Whenever your device gets wet, dry it thoroughly with a soft, dry and clean cloth. You should
dry the inside of the charging port before inserting a power connector to charge your device.
If the charging port is not fully dry, your device may operate abnormally. For example, it
may charge more slowly or overheat.
- Do not expose the device to direct sunlight.
- If the device is dropped or receives an impact, its water and dust resistance may be
impaired.
To Next Page
Loading...
