4. Clip molded plug to Power Cord to secure.
NOTICE:
While vacuuming, certain carpets and low humidity conditions may generate small static discharges.
The discharges are entirely harmless and are not associated in any way with the main power supply.
How to Maintain Your BISSELL CleanView ®
To maintain maximum cleaning performance, the following maintenance steps must be performed:
WARNING: To reduce the risk of electric shock, turn Power Switch OFF and disconnect polarized plug
from electrical outlet before performing maintenance or troubleshooting checks.
1. Empty the Dirt Container when the dirt reaches the “Full” line on the side.
2. Check the Upper Tank and Pre-Motor Filters monthly and clean or replace as needed.
3. Clean or replace the Post-Motor Filter every three months.
Note: More frequent filter cleaning may be necessary if you are vacuuming new carpet, fine dust, or
have allergy concerns. Follow the instructions on the following pages to perform these simple
maintenance steps.
Tip:
For maximum cleaning performance, Check and clean or replace all filters as suggested.
Empty Dirt Container
The Dirt Container needs to be emptied when the dirt reaches the Full line on the side of the
Container.
1. Unplug cleaner from electrical outlet.
2. Slide the Lock ‘n Seal Lever to the “Unlock” position.
3. Grasp handle and pull the Dirt Container straight out to remove from vacuum.
4. Empty dirt into garbage container.
5. Put the Dirt Container back in the vacuum and slide the lever to the “Lock” position.
Note: The Dirt Container may be washed in warm water with a mild detergent. Make sure it is
completely dry before using again.
Cleaning The Upper Tank & Louvers
To Next Page
Loading...
