ANTSPACE HK3 Water cooling container & Dry-Wet Tower Product Manual
5
Before installing or removing a power cable, turn off the power switch.
Before connecting a power cable, check that the label on the power cable is correct.
If the power cable is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
The appliance should fit with means for disconnection from the supply mains having a contact separation in
all poles that provide full disconnection under overvoltage category III conditions, and these means must be
incorporated in the fixed wiring in accordance with the wiring rules.
2.4 Mechanical Safety
Drilling Holes
Sharp Objects
The fins of the heat exchanger of dry tower are extremely sharp. Please wear protective gloves when operating
close to the fins.
Fan
When replacing a component, place the component, screws, and tools in a safe place. Otherwise,
if any of them fall into the operating fans, the fans may be damaged.
When replacing a component near fans, do not insert your fingers or boards into the operating
fans until the fans are switched off and stops running.
Moving Heavy Objects
To Next Page
Loading...