BIXOLON SLP-TX403 - Stand-alone Configuration Mode

5-2 Stand-alone Configuration Mode
• Various modes can be executed using buttons and LED only.
5-2-1 How to start stand-alone configuration mode
1) The printer mode is set to Printer Setting Mode when the Pause button is pressed
for two seconds while in Print Standby Mode.
2) Both LEDs will change to orange color and the printer will be set to Stand-alone
Configuration Mode.
3) When the printer enters into this mode, the status of LED 1 and LED 2 are changed
sequentially.
4) When the Feed button is pressed at specific LED color combination, the
corresponding printer operation will be selected.
5-2-2 List of supported functions
Sequence
number
LED 1
LED 2
Printer operation
Color
Status
Color
Status
1
Green
On
Green
Blink four times
Print Configuration Info.
2
Orange
Blink four times
Print File List
3
Red
Blink four times
Factory Reset
4
Orange
On
Green
Blink four times
Gap Sensor Auto Calibration
5
Orange
Blink four times
B/M Sensor Auto Calibration
6
Red
Blink four times
Data Dump Mode
7
Red
On
Green
Blink four times
-
8
Orange
Blink four times
-
9
Red
Blink four times
-
V10 CONSUMIBLES S.L.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309