Need help?Do you have a question about the BK Precision 9110 and is the answer not in the manual?
General| Output Current | 0 - 5 A |
|---|---|
| Dimensions | 214.5 mm x 157 mm x 88 mm |
| Weight | Approx. 2.1 kg (4.6 lbs) |
| Output Current Range | 0 - 5 A |
| Current Resolution | 1 mA |
| Ripple and Noise (CV) | ≤ 1 mVrms |
| Ripple and Noise (CC) | ≤ 3 mArms |
| Ripple and Noise | ≤1mVrms |
| Display | LCD |
| Display Type | 4.3-inch LCD |
| Interface | USB |
| Operating Temperature | 0 - 40 °C |
| Line Regulation | ≤0.01% + 3mV |
| Load Regulation | ≤0.01% + 3mV |
Explains IEC 61010 safety category ratings for electrical energy and voltage impulses.
Details the required mains power environment and voltage for operation.
Explains the necessity of safety ground connection via the power cable.
Warns against operating in the presence of flammable gases, vapors, or particulates.
Details the intended use in office-type indoor environments and lists restrictions.
Instructions on handling a damaged instrument, including removal from service.
Specifies using a clean dry lint-free cloth for cleaning, avoiding chemicals.
States the instrument is not for contact with the human body or life-support systems.
Warns about dangerous voltages inside even when powered off and handling procedures.
Fuse replacement must be done by qualified personnel following safety procedures.
Advise against substituting non-approved parts and recommend returning for service.
Emphasizes keeping air inlets/outlets clear for fan operation and airflow.
Warns not to exceed the battery manufacturer's specified discharge rate.
Use correctly sized wires and follow general safe use precautions for the instrument.
Information on the disposal of old electrical and electronic equipment in the EU.
States compliance with the Low Voltage Directive EN61010-1: 2001.
Lists EMC Directive standards the instrument complies with.
Defines CAUTION, WARNING, and DANGER symbols and their implications.
Explains symbols for Chassis (earth ground), On (Power), and Off (Power).
Describes indicators for CV, CC, OVP, OCP, Lock, Preset, and Shift modes.
Identifies keys like Save, Lock, Setup, Shift, Output On/Off, and Preset.
Explains voltage/current value display, cursor positions, and the rotary knob.
Explains how voltage/current limits recalculate to form a constant power boundary.
Provides an example of setting voltage and current for the 9110 model.
Instructions for inspecting the instrument for damage upon receipt and checking contents.
Details the universal AC input and how to switch between 110V and 220V.
Lists required fuse specifications for 110 VAC and 220 VAC operation by model.
Step-by-step guide on locating and replacing the fuse box slit.
Describes how to turn on the instrument and its behavior on power-up.
Clarifies that the 9-pin D-sub connector on the rear is for factory use only.
Explains how to use the DV/A key and cursors to set the voltage value.
Explains how to use the DV/A key and cursors to set the current value.
Describes how to toggle the output ON or OFF using the On/Off key.
Details cursor positions and corresponding voltage/current step sizes.
Explains how to lock and unlock the keyboard to prevent unintended changes.
Describes how to set Over Voltage Protection (OVP) and Over Current Protection (OCP).
Explains how to set the key sound to ON or OFF using the knob and confirmation.
Describes how to skip address mode and select group numbers for storage.
Explains how to store up to four sets of voltage/current values into memory groups.
Details how to activate Preset mode and recall stored Volt/Amp sets.
Provides solutions for common issues like output disabled or keys disabled.
Outlines the process for obtaining warranty service and returning products.
Details the process for non-warranty service and payment requirements.
Provides B&K Precision Corp. contact details and return shipping instructions.
States the warranty covers defects in workmanship and materials for one year.
Lists conditions like misuse, alterations, or serial number changes that void the warranty.
Mentions that the warranty grants specific rights varying by state.
To Next Page
