Chapter 4: Configuration
724-746-5500 | blackbox.com
Page 19
4. Configuration
4.1 Using the Configuration Menu
The configuration mode allows you to determine numerous aspects of the ServSwitch Freedom unit capabilities.
To use the configuration menu
During normal use, the seven segment display on the front panel shows the number of the currently selected computer channel.
From this condition, enter configuration mode as follows:
1. Press and hold the front panel COMPUTER button for roughly five seconds.
The display will show: C
2. On the keyboard, press the letter key for the required menu section, e.g. S (see Table 4-1 for full list of options)
The display will show the pressed letter.
3. Press the number of the required setting, e.g. 4
The display will show the pressed number.
4. Press Enter to accept the setting and return to the main menu section.
The display will show: C
5. You can now continue with your next configuration change (go to step 2), or exit from the configuration menu (see below).
To exit the configuration menu and save changes
• PressE and then press Enter to exit and save changes.
To exit the configuration menu without saving
• Presseitherofthefrontpanelbuttons.
To Next Page
Loading...
Need help?
General