T ABLE TOP MOUNT INSTALLATION
PRINTED N OVEMBER 3, 2009
1-12
Table Top Mount Without The VESA Mounting Bracket
1 Find a location on a table or elsewhere to mount the MF4100.
Ensure there is enough clearance for the operator to access the touchscreen and swipe cards.
2 Install the rubber feet provided in the hardware kit to each corner of the MF4100 plastic bottom cover.
The rubber feet are self-adhesive. The bottom cover has round depressions in the plastic to locate the
rubber feet. Install a rubber foot at each of the four corners.
Figure 1-18 Reader Rubber Feet Installation Locations
3 Install the required cables to the connectors of the MF4100.
See: MF4100 Cable Ports (Page: 7).
4 Place the security plate onto the MF4100, and then route the cables through the opening.
Figure 1-19 Table Top Mount - No VESA Bracket Cable Route
5 Secure the security plate onto the MF4100 using two M4 x 6mm machine screws provided in the
hardware kit.
To Next Page
Loading...
