Blackmagicdesign ATEM 1 M/E - Operating Your ATEM Switcher; Controlling media players on the software control panel; Controlling media players on the broadcast panel

Operating Your ATEM Switcher
43
Controlling media players on the software control panel
Step 1. From the switcher tab, select the media player palette.
Step 2. Use the select media drop down list to select a clip or still from the media pool. Clip and still
locations which have media loaded will display a filename in the drop down list.
Step 3. If you have selected a motion clip, the begin, step back, play/pause, step forward and loop
transport controls will be enabled for controlling the clip. If you want to loop a clip, then select the
loop button and press play. The media player will keep looping until selected to stop.
Controlling media players on the broadcast panel
Step 1. From the system control menu buttons, navigate to the Media Player menu by selecting MEDIA
PLAYER from the HOME menu.
Step 2. Select the media player you want to control.
Step 3. Select stills or clips mode.
Step 4. In stills mode, use the rotary encoder or the STEP BCK and STEP FWD buttons to select a still
from the media pool. In this panel, you see only the still number to show what still you have
selected.
Step 5. In clip mode, use the rotary encoder to select clip 1 or clip 2. If a clip is loaded in the media pool,
the transport controls will be enabled and can be used to play/pause, jump to begin and loop the
clip. You cannot step forward and step back on a clip from the broadcast panel.