14
PROCEDURE 4. LOAD THE THERMAL PAPER ROLL
If the instrument is experiencing a paper jam, see the procedure Clear a Paper Jam on page 44.
The BladderScan BVI 3000 has an automatic paper‑loading mechanism. When you insert the paper roll
correctly, the instrument automatically feeds the paper through the instrument and prepares for printing.
1. On the top of the control unit, open the paper well door.
2. If there is an empty paper roll in the paper well, remove it.
3. If you are loading a new paper roll, cut off the rst inch of the new paper.
4. Ensure that the end of the paper roll is cut straight. Do not fold the end of the paper roll, cut it diagonally, or
cut it to a point.
5. Turn the BVI 3000 on by pressing the power button.
6. Insert the end of a new paper roll, with the thermal side down, into the paper input slot. The
BVI 3000 senses the presence of the paper and automatically feeds the paper through the instrument.
Note: To verify that you are loading the paper with the thermal side down, ick your nail over the paper. If a
black mark appears, this is the thermal side.
7. Place the paper roll in the paper well.
8. Close the paper well door. The instrument is ready to print.
To Next Page
Loading...