BLADDERSCAN BVI 3000 - TROUBLESHOOTING; RUN A SELF TEST

41
Operations & Maintenance Manual: Maintenance & Troubleshooting
TROUBLESHOOTING
PROCEDURE 1. RUN A SELF TEST
The following tests are completed as part of the self test:
• ROM Test—Program memory
• BUS Test —Microprocessor bus
• NVRAM Test —Non‑volatile, battery‑backed memory
• SRAM Test—Main memory
• FLASH Test—Flash memory
1. Turn the BladderScan BVI 3000 on by pressing the power button.
2. On the Main Menu screen, press the ALT button.
BVI 3000
SCAN ALT
VERATHON
PRINT NOTES
13:2705/22/14
3. If you are prompted, enter your PIN code.
Note: The default PIN code is 0000.
4. On the Alternate Menu screen, press the SELF TEST button. The instrument begins the self test.
NAME TIMEDATE
Copyright 2013 by
VERATHON Corporation
VER: 3.020 (D949)
Box ID: 00001965
PREF
SELF
TEST
As the test is completed, the Self Test screen displays the status of the systems tested. When the test is
complete, the instrument returns to the Main Menu screen.
ROM Te st PASSED
Bus Te st PASSED
NVRAM Te st PASSED
SRAM Te st PASSED
FLASH Te st PASSED
5. If any of the self‑test systems does not pass, contact Verathon Customer Care or your local representative.