42
PROCEDURE 2. TROUBLESHOOT POWER ISSUES
If the instrument does not turn on, this is usually due to a dead or discharged battery and can be xed simply by
replacing the dead battery with a charged one.
1. Check the battery icon in the upper‑right corner of the LCD screen.
2. If the battery icon is clear (empty), replace the battery or recharge the current battery. For more information,
see Charge the Batteries on page 10.
3. If replacing or charging the battery does not resolve the issue, contact Verathon
®
Customer Care or your
local representative.
PROCEDURE 3. TROUBLESHOOT AN ERROR MESSAGE
BATTERY CHARGE LEVEL
When the battery’s charge is too low to allow normal operation (but not too low to permit operation of the
internal circuitry) the BVI 3000 displays the following message: BATTERY CHARGE LEVEL IS TOO LOW FOR
INSTRUMENT OPERATION. RECHARGE BEFORE NEXT USE.
BATTERY CHARGE LEVEL
IS TOO LOW FOR
INSTRUMENT OPERATION.
RECHARGE BEFORE NEXT USE.
1. Replace the battery or recharge the current battery. For more information, see Charge the Batteries on
page 10.
NO SCANHEAD
The following image is displayed if the user presses the SCAN button when the scanhead is not connected to
the control unit.
1. Connect the scanhead to the control unit according to the instruction in the procedure Connect the
Scanhead to the Control Unit on page 13. When the scanhead is properly attached to the control unit, the
error disappears, and the instrument operates normally.
To Next Page
Loading...