BLADDERSCAN BVI 3000 - Page 51

43
Operations & Maintenance Manual: Maintenance & Troubleshooting
PRINTHEAD DISENGAGED
The instrument senses when the printhead is disengaged and displays the following image until the printhead
release lever is positioned up as far as it can go.
1. Turn the printhead release lever so that it is pointing to 10 o'clock.
NO PAPER
The BVI 3000 displays the following image when the printer is out of paper.
1. Load paper according to the instructions in the procedure Load The Thermal Paper Roll on page 14.
TOO HOT
The BVI 3000 displays the following message if the printhead overheats.
TOO HOT
1. Turn off the BVI 3000, and then wait for the instrument to cool down.
2. Ensure that this is not the result of a paper jam. For more information, see Clear a Paper Jam on
page 44.
3. If the printhead continues to overheat, contact Verathon
®
Customer Care or your local representative.
RESCAN (INTERFERENCE)
The BVI 3000 displays the message RESCAN if it detects interference of sufcient magnitude to possibly
compromise measurement accuracy. For more information, see Electromagnetic Compatibility on page 54.
1. Locate the source of the interference.
2. Disable or remove the interference source, or use the BVI 3000 away from the interference source.
3. If these efforts do not restore normal operation, contact Verathon
®
Customer Care.