9
Oven cleaning and maintenance
Changing the light bulb
The light is situated on the top right hand corner of the rear
panel. To get access to the light bulb, first unscrew the light
cover (anticlockwise). Remove the bulb by unscrewing it
(anticlockwise). Replace with a similar globe (E14: 230-
240V, 25W, 300 °C).
Warning! Cleaning should be done with the oven power
switched off. Take the plug out of the socket or switch
off the oven’s power circuit.
Do not use aggressive or abrasive cleaning products,
scourers that scratch surfaces or sharp objects, since stains may appear.
Do not use high pressure or steam jet cleaning appliances.
Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since
they can scratch the surface, which may result in shattering of the glass.
Front surface
Normally you just need to clean the oven with a damp cloth. If it is very dirty, add a few drops of
dishwashing liquid to the cleaning water. Afterwards, wipe the oven with a dry cloth.
Oven interior
To remove dirt that is hard to shift, use a non-aggressive cleaning product. Do not use oven sprays or
other aggressive or abrasive cleaning products.
Always keep the door and the oven front very clean to ensure that the door opens and closes
properly.
Make sure water does not enter the oven ventilation holes.
Accessories
Clean the accessories after each use. If they are very dirty, soak them first of all and then use a brush
and sponge. The accessories can be washed in a dish washing machine.
Removing the door
Open the door fully. To lock the hinges in place, either rotate the bracket at the top of the hinge out of
the way or fit a small pin into the hole through the hinge. Carefully pull the door away from the oven.
Replacement is in the opposite order.
The inner glass can be removed by carefuly pulling the glass towards the top of the door, and then
rotating out. Replacement is in the opposite order. Always place the door and door glass on flat, clean
surfaces. Take care not to scratch the glass.