11
Installation instructions
Before installation
Check that the input voltage indicated on
the characteristics plate is the same as the
voltage of the power outlet you are going to
use.
Open the oven door and take out all the
accessories and remove the packing
material.
Warning! The front surface of the oven may
be covered in a protective film. Before using
the oven for the first time, carefully remove
this film, starting on the inside.
Make sure that the oven is not damaged in
any way. Check that the oven door closes
correctly and that the interior of the door and
the front of the oven opening are not
damaged. DO NOT USE THE OVEN if the
power cable or the plug is damaged, if the
oven does not function correctly or if it has
been damaged or dropped.If you find any
damage contact our Customer Relations
department.
Put the oven on a flat and stable surface. The
oven must not be installed close to any
sources of heat, radios or televisions.
During installation, make sure that the
power cable does not come into contact
with any moisture or objects with sharp
edges and the back of the oven. High
temperatures can damage the cable.
Warning: after the oven is installed you
must make sure you can access the plug.
After installation
The oven is equipped with a power cable and
a plug for single phase (household) current,
230-240V ~ 50Hz.
If the oven is to be installed on a
permanent basis it must be installed by a
qualified technician. In such a case, the oven
should be connected to a circuit with an all-
pole circuit breaker with a minimum
separation of 3 mm between contacts.
WARNING: THE OVEN MUST BE
EARTHED.
The manufacturer and retailers do not
accept responsibility for any damage that
may be caused to persons, animals or
property if these installation instructions are
not observed.
To Next Page
Loading...
Need help?
General
