110
User settings
Adjust the desired volume with the rock-
er switch
or = (levels 0 to 66).
Notes:
The volume preset by you will not be
used,
if the volume currently listened to is
lower than the set mute level. In this
case, traffi c announcements are re-
produced with the volume listened to.
if the volume currently listened to is
higher than the set TEL volume. In
this case, phone calls/navigation an-
nouncements are reproduced with
the volume listened to.
if the volume currently listened to is
higher than the set TA volume. In this
case, traffi c announcements are re-
produced with the volume listened to.
Activating/deactivating the signal tone
(BEEP ON/OFF)
You can deactivate the signal tone that
sounds as a confi rmation in the menus or
when storing the stations on the station but-
tons.
In the Volume menu, press the rock-
er switch
or = repeatedly until
"BEEP ON/OFF" is displayed.
Switch between the settings with the
rocker switch
or :.
"BEEP OFF" (signal tone off)
"BEEP ON " (signal tone on)
쏅
•
•
•
쏅
쏅
•
•
Setting the speed-dependent volume
increase (AUTO SOUND )
When you are driving faster, the device can
automatically increase the volume to com-
pensate for the driving noise. The volume is
increased depending upon the speed. In or-
der for this to work, the speedometer signal
must be connected as described in the in-
stallation instructions.
The optimum setting for this volume in-
crease depends on how noise levels devel-
op in your particular vehicle. Try the setting
that is perfect for your vehicle. You can se-
lect a value between 0 (no increase) and
max. 5.
In the Volume menu, press the rock-
er switch
or = repeatedly until
"AUTO SOUND" is displayed.
Press the rocker switch
: to display
the setting.
Set the desired value with the rocker
switch
or =.
쏅
쏅
쏅
02_BA_Hamburg_gb.indd 11002_BA_Hamburg_gb.indd 110 26.03.2007 11:34:10 Uhr26.03.2007 11:34:10 Uhr
To Next Page
Loading...
Need help?
General
Weight and Dimensions
