34
Selecting a display illumination during a
colour scan
Press the MENU/OK button ;.
Press the
or button < repeat-
edly until "COL SCAN" appears on
the display.
Press the MENU/OK button ; to
start the colour seek.
The device starts changing the display
illumination colour.
To select the currently set colour,
press the MENU/OK button ;.
With the MENU/OK button ;, you can
start the colour seek again and select a
different colour.
If you found and selected the desired
colour,
press the ESC/DIS button 5.
쏅
쏅
쏅
쏅
쏅
External audio sources
External audio sources, such as portable
CD players, MiniDisc players or MP3 play-
ers, can be connected to the device in two
ways:
Via the rear AUX input (if no CD changer
is connected to the device).
Notes:
An adapter cable is needed to con-
nect an external audio source via the
rear AUX input. You can obtain this ca-
ble (Blaupunkt no.: 7 607 897 093)
from your Blaupunkt dealer.
With the SOURCE button =, you can
select the rear AUX input. The display
then shows "CDC / AUX".
2. Via the front AUX-IN socket.
Note:
As soon as an audio source is connect-
ed to the front AUX-IN socket, it can be
selected with the SOURCE button =.
The display then shows "AUX".
1.
•
•
Display External audio sources
01_KingstonMP47_NRDS_eng.indd 3401_KingstonMP47_NRDS_eng.indd 34 2/8/07 7:05:48 PM2/8/07 7:05:48 PM
To Next Page
Loading...
