Blaupunkt TravelPilot Lucca 5.2 - Deleting a Complete Route List; Calculating a Route; Displaying the Route on the Map; Simulation

24
Navigation
Deleting a Complete Route List
Prerequisite:
You opened the route list to be deleted.
Touch the More button.
Touch Delete entire list.
Touch OK.
Calculating a route
A planned route can also be calculated without
GPS reception so that you can gain an overview of
the trip before you start out.
In this case, the fi rst defi ned route point is set as
the starting point of the route.
Note:
For a navigation, the current position is the
starting point. The fi rst stage is the travel to
the fi rst defi ned route point.
Touch the Calculate button to calculate the
complete distance as well as the estimated
travel time of the route.
The route is being calculated. A window dis-
plays the progress of the calculation.
After the calculation is complete, the Itinerary
menu displays the complete trip from the fi rst
to the last route point and the estimated travel
time for this trip instead of the Calculate but-
ton.
In addition, the distance from the previous
route point and the estimated travel time for
this stage are displayed for each route point.
Displaying the Route on the Map
Touch the Display button to display the com-
plete route on the map.
The map is displayed.
The route is highlighted in blue.
The specifi ed route points are identifi ed by
fl ags.
•
쏅
쏅
쏅
쏅
쏅
Simulation
On the second page of the navigation menu,
touch the Simulation button.
The Simulation menu is displayed.
Touch the upper F
rom: butt
on to specify a
starting point.
The destination entry appears. Enter a start-
ing point. If necessar
y, read the c
hapter "En-
tering a destination" again.
Touch the Add t
o simulation button.
Touc
h the lower To: button to specify a desti-
nation point.
The destination entr
y appears. Enter a desti-
nation point.
Touc
h the Add to simulation button.
Touc
h Start simulation.
The simulation starts.
Touc
h the
button to quit the simula-
tion. Otherwise, the simulation is repeated.
Note:
The simulation distance must be less than
100 kilometres.
Defi ning routing options
In the Routing options menu, you can defi ne the
speed profi le of your vehicle, select the type of
routing and exclude certain streets from usage.
The Routing options are retained for every subse-
quent destination guidance.
In the Navigation menu, touch the Routing
options button.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Lucca_5_2_long_1_GB.indd 24Lucca_5_2_long_1_GB.indd 24 07.12.2006 11:26:45 Uhr07.12.2006 11:26:45 Uhr