Installation in the Vehicle
9
Installation in the Vehicle
For temporary installation in a vehicle, the Lucca
features a suction cup holder with a suction cup to
attach it to the windshield.
Caution:
Install the Lucca so that it does not block your view
and does not distract from the traffi c.
Do not install the Lucca in the airbag deployment
area.
Ensure that the Lucca does not pose a threat to
passengers in the vehicle in case of emergency
braking.
Attaching the Support
The Lucca can be installed in the vehicle in a sim-
ple way using the supplied suction cup holder.
Locate a suitable place for installing the Lucca.
To ensure a perfect hold, the glass must be
free of dust and oil. If necessary, clean the
glass fi rst using a lens cleaning tissue.
Press the suction plate of the support against
the glass.
Push the lever on the suction support towards
the glass.
The holder can now be adjusted. The track
for mounting the Lucca must be aligned ver-
tically.
Removing the Support
If you change vehicles, you can simply remove the
support.
Push the lever on the suction support away
from the glass.
Carefully loosen the suction plate at the edge
from the glass so that air can enter between
suction cup and glass.
Carefully pull the suction cup off of the glass.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Attach the Connect Cradle
The suction cup holder f
eatures a mount for the
Connect Cradle. The Connect Cradle e
xpands the
functions of the Lucca. The chapter "Connect Cra-
dle" provides information about connecting the
Connect Cradle to your car sound system.
Snap the Connect Cradle with the suction cup
holder into position.
Installing Lucca in the Connect Cradle
The Lucca features an opening on the underside
f
or mounting the Connect Cradle.
Detach the elastic co
ver on the underside of
the housing.
Place the Lucca on the mount of the Connect
Cradle and snap the L
ucca to the rear and int
o
position.
Removing the Lucca
Press the lever of the Connect Cradle at the
rear side of the Lucca and pull the Lucca to
the front.
Remove the Lucca to the top and out of the
Connect Cradle.
To protect the contacts, you can apply the elastic
co
ver and dummy SD car
d again after using the
Lucca.
쏅
쏅
쏅
쏅
쏅
Lucca_5_2_long_1_GB.indd 9Lucca_5_2_long_1_GB.indd 9 07.12.2006 11:26:41 Uhr07.12.2006 11:26:41 Uhr
To Next Page
Loading...
