Confi guring Lucca
35
Touch the Set as home address button.
The address is copied into the Home addr
ess
menu.
Touch OK.
Map information
Touch the Map inf
ormation button.
The
Map information menu is displayed.
If you activate the entry Inf
o bar, the compass,
altitude and current speed are displayed on the
map in the lower right border.
Activate the Point of interest entry so that
all points of interest are displayed on the map
(default setting).
Activate the Street names (2D) entry so that
the street names are displayed on the map
(only possible in 2-D display).
Touch OK.
Route information
In the R
oute information
menu, you can perform
the following settings:
Touch the Rout
e information butt
on.
The Route information menu is displayed.
You can now select the following settings:
Complete: The points apply to the entire
r
oute. If you ent
ered only one destination,
only this destination applies.
Stage: These points apply to the next route
point.
Distance: Activate this point to display
the distance to the destination.
Duration: Activate this point to display
the duration until the arrival.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
•
•
–
–
Arrival time: A
ctivate this point to dis-
play the estimated time of arrival.
Touch the buttons to switch the settings on
or off.
Touch OK.
Route planning
In the Itinerary menu, you can defi ne whether the
calculation for the next stage should automatically
be performed after reaching a stage.
If the automatic calculation is activated, the route
to the next stage destination is automatically cal-
culated upon reaching a stage.
If the automatic calculation is deactivated, you
can navigate to the next stage destination by brief-
ly touching any position on the map and selecting
the option Next destination.
Touch the Itinerary button.
Touch the Automatic button to switch the au-
tomatic route calculation on or off.
Touch OK.
TMC
In the TMC menu you can specify whether the Luc-
ca should automatically perform route changes in
case of traffi c obstructions or wait for manual con-
fi rmation.
Touch the TMC button.
Touch the Route change button to toggle be-
tween the settings Automatic and Confi rm
manually.
Touch OK.
Note:
A detailed description of the TMC functional-
ity can be found in the chapter "Using the TMC
functionality".
–
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Lucca_5_2_long_1_GB.indd 35Lucca_5_2_long_1_GB.indd 35 07.12.2006 11:26:48 Uhr07.12.2006 11:26:48 Uhr
To Next Page
Loading...
