Navigation
29
Activate the Point of interest entry so that
all points of interest are displayed on the map
(default setting).
Activate the Street names (2D) entry so that
the street names are displayed on the map
(only possible in 2-D display).
Touch the
button to return to the Set-
tings menu.
Route Information
In the Settings menu, touch the Route infor-
mation button.
The Route information menu is displayed.
Switch the desired route information on or off
with the corresponding buttons.
The corresponding information for the next
stage (upper area) and the complete route
(lower area) is displayed on the map.
Touch the button to return to the Set-
tings menu.
Signpost information
On the second page of the Settings menu,
touch Signpost information.
The Signpost information menu is displayed.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Touch the Show traffi c signs button to acti-
vate or deactivate the display of the exit traf-
fi c signs.
Touch the
button to return to the Set-
tings menu.
Speed
On the second page of the Settings menu,
touch Speed.
The Speed menu opens.
In the Speed menu you can defi ne whether speed
limits should be displayed during the navigation
and whether you should be warned audibly if you
are exceeding the speed limit.
Display signs
Touch the Show traffi c signs button to switch
among the modes Always, On speeding only
or Never.
Warning in urban areas
The Warning in urban areas button
shows the level of the speed-reading at
which you are audibly warned inside of
build-up areas.
Touch the Warning in urban areas button to
change the value or to set it to Never.
Warning in rural areas:
The Warning in rural areas button shows
the level of the speed-reading at which
you are audibly warned outside of build-
up areas.
쏅
쏅
쏅
•
쏅
•
–
쏅
•
–
Lucca_5_2_long_1_GB.indd 29Lucca_5_2_long_1_GB.indd 29 07.12.2006 11:26:47 Uhr07.12.2006 11:26:47 Uhr
To Next Page
Loading...
