ELECTRIC CONVECTION OVENS 8 INSTALLATION
UTILITY CONNECTION
ELECTRICAL CONNECTION - MARK V XCEL
Wiring diagrams are located in the control compartment and on the back of the oven.
The electric motor, indicator lights and related switches are connected to the oven as follows:
1. Remove the bottom trim and control panel covers. Slide the control panel forward.
2. Connect the supply conduit to the wire duct located in the lower left hand corner on the back of the oven.
3. Run the supply wires through the duct to the front of the oven.
4. Connect the supply wires to top of right contactor in the control compartment at the lower right corner of the oven.
5. Reinstall the bottom trim and control panel covers.
NOTE: To prevent damage there is no power to the heating elements when the blower is not operating.
THE BLODGETT OVEN COMPANY CANNOT ASSUME RESPONSIBILITY FOR LOSS OR DAMAGE SUFFERED AS A
RESULT OF IMPROPER INSTALLATION.
Install incoming
power on this
contactor
Figure 6
MARK V XCEL
VOLTAGE
HZ
KW
PHASE
MAX LOAD (AMPS
MOTOR
L1 L2 L3 N
U.S. and Canadian installations
208 60 11.0 1 53 — 53 — 6 AWG
208 60 11.0 3 33 28 33 — 8 AWG
220-240 60 11.0 1 50 — 50 — 6 AWG
220-240 60 11.0 3 28 23 28 — 8 AWG
440 60 11.0 3 16 13 16 — 12 AWG
480 60 11.0 3 15 12 15 — 12 AWG
General Export installations
220-240 50 11.0 1 50 — 50 — Size per local code
240/415 50 11.0 3 19 14 14 5 Size per local code
220/380 50 11.0 3 17 15 15 4 Size per local code
230/400 50 11.0 3 19 14 14 5 Size per local code
To Next Page
Loading...
Need help?
General
