Patient Monitor User’s Manual
2-2
Do not come into contact with the patient during
defibrillation. Otherwise serious injury or death could
result.
When the monitor is connecting with high-frequency
devices, sensors and cables should avoid touching
high-frequency devices, in order to leakage current
burns patient.
The monitor is not designed for the sterilized room.
The monitor should be handled with care so as to
avoid shocks and falls.
When the monitor is in use, it must be ensured the
batteries have sufficient capacity; otherwise there
might be such phenomena as starting-up
abnormalities or inaccurate measurement data, etc.
The use of accessories, sensors, and cables other than
those specified may result in increased emission, low
anti-disturbance and/or create invalid readings of the
monitor. It is advised to check it at least once a month.
The physiological data and alarm messages displayed
on the monitor are for reference only and cannot be
directly used for diagnostic interpretation.
Disposable devices are intended for single use only.
They should not be reused as performance could
To Next Page
Loading...