Patient Monitor User’s Manual
8-2
8.2 Charging the Battery
To charge the battery:
1. Connect the Micro USB in power adapter,
2. Connect the other connector of Micro USB in the monitor,
and plug the adapter into the AC mains,
3. The indicating lamp on the monitor is on to indicate that
the battery is in charge,
4. When the battery charging indicating lamp on the monitor
turns off, the battery is fully charged.
8.3 Optimizing Battery Performance
A battery needs at least two optimizing cycles when it is put
into use for the first time. A battery cycle is one complete,
uninterrupted charge of the battery, followed by a complete,
uninterrupted discharge of the battery. A battery should be
conditioned regularly to maintain its useful life. Condition a
battery once when it is used or stored for two months, or when
its run time becomes noticeably shorter.
To optimize a battery, follow this procedure:
1. Disconnect the monitor from the patient and stop all
monitoring and measuring procedures.
To Next Page
Loading...