Patient Monitor User’s Manual
5-9
alarm limit should greater than the lower one.
5.6.3 Setting CO2 Scan Speed
Select scan speed of CO2 waveform. Click the right of
【Speed】, you can select “6.25 mm/s、12.5mm/s, 25 mm/s”.
5.6.4 Setting CO2 Unit
Click the right of 【CO2 Unit】, you can select “mmHg、%、
kPa”.
5.6.5 Setting Scale
You can adjust the position of wave scale manually, and the
waveform amplitude will vary along with it. Click the right of
【Scale】, you can select “61mmHg、76mmHg、91 mmHg、
106 mmHg”.
5.6.6 Setting Apnea Alarm
You can select the apnea time as required in the options. The
monitor indicates an alarm when a pre-adjusted time has elapsed
since the last detected breath. Click the right 【Apnea Alm】,
you can select “Off, 5s, 10s, 20s, 40s, 60s, 80s, 100s, 120s”.
To Next Page
Loading...
Need help?
General